Codes, Transmission Allocations, Ratios, Capacities (AUDI A4 From My 2008)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
| Rear Final Drive |
|
0BF |
| Codes |
|
LFU |
LFV |
LFW |
| Ratio |
Final drive Z2
: Z1 |
35 : 9 = 3.889 |
37 : 9 = 4.111 |
43 : 13 = 3.308 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
| Rear Final Drive |
|
0BF |
| Codes |
|
LGH |
LGJ |
MBV |
| Ratio |
Final drive Z2
: Z1 |
37 : 10 = 3.700 |
35 : 8 = 4.375 |
35 : 9 = 3.889 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
| Rear Final Drive |
|
0BF |
| Codes |
|
MBW |
MKU |
MKV |
| Ratio |
Final drive Z2
: Z1 |
37 : 10 = 3.700 |
37 : 9 = 4.111 |
43 : 13 = 3.308 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
| Rear Final Drive |
|
0BF |
| Codes |
|
MKW |
MKX |
MKY |
| Ratio |
Final drive Z2
: Z1 |
35 : 8 = 4.375 |
35 : 9 = 3.889 |
37 : 10 = 3.700 |
| Driveshaft flange diameter |
|
75.5 mm |
75.5 mm |
75.5 mm |
Gear oil - capacity
- For rear final drive (differential and pinion)
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |
ATF capacity
- For the hydraulic control unit and chambers
- No replacement interval
|
Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article
. |