Codes, Transmission Allocations, Ratios And Capacities (AUDI A8 From My 2010)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

In the Audi A8 from My 2010 two different versions of rear final drive are installed, rear final drive 0BF or 0BE.

The rear final drive 0BE is an enhanced version and is installed exclusively with the V8 TDI Engine.

Rear Final Drive			0BF
Codes			MKV
Allocation	Engine		3.0L - 155 kW TDI 3.0L - 184 kW TDI 3.0L - 213 kW TFSI 3.0L - 245 kW TFSI 4.2L - 273 kW FSI 6.3L - 368 kW FSI
Ratio		Final drive Z₂ : Z₁	43 : 13 = 3.308
Driveshaft flange diameter			75.5 mm
Gear oil - capacity For rear final drive (differential and pinion) No replacement interval			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .
ATF capacity For the hydraulic control unit and chambers No replacement interval			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .

Rear Final Drive			0BE
Codes			MKL
Allocation	Engine		4.2L - 258 kW V8 TDI
Ratio		Final drive Z₂ : Z₁	36 : 13 = 2.769
Driveshaft flange diameter			68 mm
Gear oil - capacity For rear final drive (differential and pinion) No replacement interval			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .
ATF capacity For the hydraulic control unit and chambers No replacement interval			Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article .