General Notes
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
- Charge air system must be properly sealed.
- Always replace self-locking nuts.
- Charge air hoses and pipes as well as their connections must be free of oil and grease before re-installation.
- Do not assemble charge air hoses and pipes with lubricants containing oils, only coat with water (without additives) if necessary.
- Note installation marks on hoses and components.
- All hose connections for charge air system are secured by spring-type clamps or by connector couplings.
- Install only approved clamps for securing hose connections
- Spring Type Clip Pliers or Hose clamp pliers are recommended for installing spring clamps.
- For connector couplings, always note the following points:
-- Release connector coupling by pulling securing clip -arrow-.
-- Disconnect the hose and line without the assistance of tools.
-- When assembling, make sure the retaining tabs -A- are engaged securely.