Gear Oil Level In Rear Final Drive 0BF And 0BE, Checking
Test requirement
- Gear oil temperature: 10°C to 60°C (50°F to 140°F)
- The rear final drive must be in its installed position.
- The vehicle must horizontal.
- Overview of the gear oil plugs, refer to Figure and Figure
Special tools and workshop equipment required
- Catch tray
Rear Final Drive 0BF
-- Remove the gear oil inspection plug -arrow- located on the right side of the final drive.
Rear Final Drive 0BE
-- Remove the gear oil inspection plug -1-.
Continuation for All Rear Final Drives
- The fluid level is correct when the rear final drive is filled up the lower edge of the fluid fill hole.
-- Fill the gear oil if necessary.
-- Install and tighten the gear oil inspection plug -arrow-. Tightening specifications -item 22- REAR FINAL DRIVE OVERVIEW => List Item:Gear Oil Inspection Plug