Cylinder Head Bank 1 (Right), Removing: Procedure

-- Remove the right turbocharger, refer to TURBOCHARGER, REMOVING AND INSTALLING .

-- Remove the right camshafts, refer to REMOVING .

-- Remove the front bumper cover, refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

-- Remove the Cylinder Head Coolant Valve -N489- from the bracket and push it forward.

-- Install the Engine Support Bridge 10-222A on the left and right suspension strut towers as shown.

-- Mount the assembly appliance as shown.

-- Tighten the Engine Crane Adapter - Bracket T10013 with the threaded pin -1- of the Engine Support Bracket T10338 in the left front threaded hole in the cylinder block as shown in the illustration.

-- Engage the carabiner hook of the Engine Support Bridge - Spindle 10-222A/11 on the Engine Crane Adapter - Bracket T10013 and pretension the engine slightly.

-- Remove the generator, refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove the right engine mount, refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Remove the nut -2- and free up the ground wire.

-- Remove the bolts -arrows- and remove the right engine support -1-.

-- Disconnect the vacuum hoses -arrows-.

-- Remove the Intake Manifold Runner Control Valve -N316- -1- from the bracket and free up the wires at the right intake manifold -2-.

-- Disconnect the connector -arrow- for the Fuel Pressure Sensor -G247-.

-- Disconnect the connector -2- for the Intake Manifold Runner Position Sensor -G336-.

-- Move the noise insulation -1- to the side.

-- Disconnect electrical connector -arrow- from the fuel injectors.

-- Remove the Locking Pin T40071.

-- Remove the bolts -arrows-.

-- Loosen the cylinder head bolts in the sequence -1 to 10-.

-- Remove the bolts and the cylinder head carefully.

-- Lay the cylinder head on a soft surface, such as foam.