Removing the Ignition Coils from Cylinder Bank 2

-- Disconnect the connector -1- from the Engine Coolant Level Warning Switch -F66- on the bottom of the coolant reservoir and then move the coolant reservoir to the side with the coolant hoses -arrows- still connected.

Fig 1: Connector & Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- from the coolant reservoir.

-- Remove the screws -arrows- and disconnect the connectors on the ignition coils.

Fig 2: CMP Sensor And Exhaust Camshaft Control Valve Cylinder Bank 2 (Left)

Courtesy of AUDI OF AMERICA, LLC

-- Move the wiring harness slightly down.

Continuation for both sides: 

-- Remove the ignition coils using the Puller T40039 -arrow-.

Fig 3: Identifying Ignition Coil Puller T40039 Removing Ignition Coils

Courtesy of AUDI OF AMERICA, LLC

-- Remove spark plugs with Spark Plug Wrench 3122B.