Hydraulic Control Module, 0BE, 0BF: Installing: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2014 Audi S6, 2014 Audi A6 Quattro, and 2013 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Follow all Safety Precautions exactly when replacing the hydraulic control unit. Install the "old" sensors again if possible. Refer to SAFETY PRECAUTIONS AND TEST PROCEDURES
Conditions:
- Replace the seal between the hydraulic control unit -1- and the final drive housing.
- The centering pins -item 18- in HYDRAULIC CONTROL UNIT, 0BE, 0BF must be installed inside the housing for the hydraulic control unit.
- The left -6- and right -7- lines must be installed loosely when attaching the hydraulic control unit -1-.