All Wheel Drive Pump -V415-, 0BE, 0BF: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2014 Audi S6, 2014 Audi A6 Quattro, and 2013 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the vehicle on a lift.

The ignition is off.

-- Place Drip Tray under rear final drive.

-- Disconnect the connector -1- from the All Wheel Drive Pump -V415- -2-.

Fig 1: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the 4 bolts that connect the All Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball SocketT10058.

-- Carefully remove the All Wheel Drive Pump -V415- -2-. Pay close attention to the adapter -item 4- in HYDRAULIC CONTROL UNIT, 0BE, 0BF inside the hydraulic pump while doing this.

NOTE:

The adapter could fall out when removing the All Wheel Drive Pump -V415-.

Insert the adapter into the recesses in the hydraulic pump before installing the All Wheel Drive Pump -V415-.