Overview - Ignition System
WARNING: This page is about a different car, the 2015 Audi A6 Quattro, 2014 Audi A6 Quattro, 2013 Audi A6, and 2012 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Camshaft Position Sensor -G40-
- Removing and installing, refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING .
- O-Ring
- Replacing
- Knock Sensor
- Cylinder bank 1 (right) Knock Sensor 1 -G61-
- Cylinder bank 2 (left) Knock Sensor 2 -G66-
- Removing and installing, refer to KNOCK SENSOR, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Spark Plug
- Replacement interval, refer to Maintenance Tables.
- Tightening specification, refer to => 411.
- Ignition Coil
- Removing and installing, refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
- Wiring Harness
- Engine Speed Sensor -G28-
- Removing and installing, refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replacing
- Camshaft Position Sensor 2 -G163-
- Removing and installing, refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- 9 Nm