Adjustment Buffer, Adjusting

-- Install the adjusting screw -2- and cap -1- all the way into the adjusting buffer -3- before adjusting the rear lid.

Fig 1: Identifying Adjustment Buffer

Courtesy of AUDI OF AMERICA, LLC

-- Remove the adjusting screw just far enough until the cap touches the stop on the rear lid when the lid is closed.

-- Push and pull on the side edges of the rear lid under the rear window to make sure there is no play and that it closes flush.

-- Repeat the adjustment if necessary.

Installing the Stop 

-- Tighten the bolt -1- to the tightening specification when installing the stop -2-, refer to -item 3- OVERVIEW - STOP AND ADJUSTING BUFFER .

Fig 2: Identifying Stop, Rear Lid Side

Courtesy of AUDI OF AMERICA, LLC

-- Height adjustment is carried out using adjusting buffer on body side.