LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2013 >> RS 5 >> Repair and Diagnosis >> External Pages >> Different car >> Section 676 (2.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CJAA & CVCA (Hatchback)) >> 15 Cylinder Head And VALVETRAIN >> Specifications >> Fastener Tightening Specifications >> Frame Tightening Specifications and Sequence

Frame Tightening Specifications and Sequence

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Bearing Frame Bolts/Nuts Tightening Sequence
GWWN15-10483Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in 2 steps and in the sequence shown:

Stage Bolts Tightening Specification
1. -1- through -24- Install all the way in by hand.
  • The guide frame must touch the entire contact surface on the cylinder head.
2. -1- through -24- 10 Nm
scientia non olet · About LEMON Manuals