Cylinder Head Cover: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER .

-- Open the clamps -arrows- and move the upper toothed belt guard to the right.

Fig 1: Removing Upper Toothed Belt Guard

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the fuel injector and high pressure reservoir (rail), refer to FUEL INJECTORS .

-- Press the release buttons and remove the crankshaft housing ventilation hose -1- from the cylinder head cover.

Fig 2: Identifying Release Buttons

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -arrow- on the Charge Pressure Actuator Position Sensor -G581-.

Fig 3: Charge Pressure Actuator Position Sensor -G581 Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the vacuum lines from the bracket on the cylinder head cover.

-- Loosen and remove the cylinder head cover bolts in the following sequence -7- through -1-.

Fig 4: Identifying Head Cover Bolts Through Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cylinder head cover.