Toothed Belt Overview
WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Toothed Belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing and installing, tensioning TOOTHED BELT
- Bolt
- Use Counter Support 3415 to loosen and tighten
- Do not lubricate or grease the threads or collar
- Additional rotation can occur in several stages
- Replace after removing
- 120 Nm +90°
- Crankshafts - Toothed Belt Gear
- Bolt
- 20 Nm
- Idler Roller
- Bolt
- 20 Nm +45°
- Tensioning Roller
- Remove the engine bracket to remove and install ENGINE BRACKET .
- Bolt
- 20 Nm +45°
- Camshaft Sprocket
- Bolt
- 20 Nm
- Bolt
- 100 Nm
- Hub
- Use Counterholder T10051 to loosen and tighten
- To remove, use PULLING FIXTURE T10052
- Removing and installing.
- Rear Toothed Belt Cover
- Make sure it fits correctly on the cylinder head cover, refer to Installing
- Bolt
- 20 Nm
- Bolt
- Replace after removing
- 10 Nm
- Idler Roller
- Bolt
- Replace after removing
- 50 Nm +90°
- Hub
- Use Counterholder T10051 to loosen and tighten
- Use the Ignition Coil Puller T40064 to remove.
- Removing and installing. Refer to CAMSHAFT .
- Bolt
- 95 Nm
- Toothed Belt Gear for the High Pressure Pump
- Removing and installing. Refer to HIGH PRESSURE FUEL PUMP .
- Bolt
- 20 Nm
- Coolant Pump
- Removing and installing. Refer to COOLANT PUMP .
- Bolt
- 15 Nm
- Toothed Belt Cover Upper Section
- Toothed Belt Cover Lower Section
- Toothed Belt Cover Center Section
- Bolt
- Replace after removing
- 10 Nm
- Bolt
- Replace after removing
- 10 Nm +90°
- Belt Pulley/Vibration Damper
- Assembly is only possible in one position because of the offset holes.
- Bolt
- 5 Nm
- Shield
- Bolt
- Follow the tightening sequence ENGINE BRACKET .
- Replace after removing
- 40 Nm +180°
- Engine/Transmission Support
- For removing and installing, refer to ENGINE BRACKET .