LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2013 >> RS 5 >> Repair and Diagnosis >> External Pages >> Different car >> Section 559 (2.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CBFA & CCTA (Convertible)) >> 15 Cylinder Head, VALVETRAIN >> Specifications >> Fastener Tightening Specifications >> Notes

Fastener Tightening Specifications: Notes

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Balance Shaft to Cylinder Block Bolt - 9
Balance Shaft Timing Chain Guide Rail to Cylinder Block Guide Pin - 20
Balance Shaft Timing Chain, Chain Tensioner to Cylinder Block (2) - 65
Balance Shaft Timing Chain Tensioning Rail to Cylinder Block Guide Pin - 20
Ball Stud to Cylinder Head Cover - 5
Bearing Bracket to Cylinder Head Bolt - 9
Bearing Bracket to Exhaust Camshaft Bolt (1)
- M6 8 + 90°
M8 20 + 90°
Camshaft Adjustment Valve 1 to Upper Timing Chain Cover Bolt - 9
Camshaft Position Sensor to Cylinder Block Bolt - 9
Camshaft Timing Chain, Chain Tensioner to Cylinder Block Bolt - 9
Camshaft Timing Chain Guide Rail to Cylinder Block Guide Pin - 20
Camshaft Timing Chain Tensioning Rail to Cylinder Block Guide Pin - 20
Control Valve to Intake Camshaft (4) - 35
Heat Shield to Retainer Bolt - 9
Heat Shield to Cylinder Head Bolt - 20
Mounting Plate/Water Connection to Cylinder Head Bolt - 9
Oil Dipstick Guide Tube/Camshaft Adjustment Valve 1 to Upper Timing Chain Cover Bolt - 9
Oil Dipstick Guide Tube to Cylinder Head Bolt - 9
Secondary Air Injection Solenoid Valve to Cylinder Head Bolt (3) - 9
Transport Strap to Cylinder Head Bolt - 25
Vacuum Pump to Cylinder Head Bolt M6 x 70 9
(1) : Always replace after removing.
(2) : Install using liquid locking fluid.
(3) : Engine code CBFA only.
(4) : Has left hand threads.
scientia non olet · About LEMON Manuals