Camshaft Timing Chain Overview
WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Chain Tensioner
- Is under tension.
- Secure the Locking Pin T40011 or Tensioner Locking Tool T40267 depending on the version
- Timing Chain Tensioning Rail
- Guide Pin
- 20 Nm
- Bolt
- 9 Nm
- Control valve
- 35 Nm
- Left hand threads.
- Remove using the Central Valve Assembly Tool T10352.
- Bolt
M6 bolt - 8 Nm + an additional 90° (1/4) turn.
M8 bolt: - 20 Nm + an additional 90° (1/4) turn.
- Always replace.
- Washer
- Bearing Bracket
- Camshaft Timing Chain Guide Rail
- Cylinder Head Cover
- Camshaft Timing Chain
- Before removing, mark the rotation direction with paint.
- Removing and installing, refer to CAMSHAFT TIMING CHAIN .
- Camshaft Timing Chain Guide Rail
- Guide Pin
- 20 Nm
- Sprocket
- Note the installed position, refer to Fig 2.
- Both surfaces -arrows- must line up across from each other.