Overview - Timing Chain Cover: Notes
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace
- Tightening specification and sequence. Refer to Figure.
- Crankshaft Shaft Seal, Transmission Side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Bolt
- Replace
- Tightening specification and sequence. Refer to Figure.
- Alignment Sleeve
- Quantity: 2
- Threaded Pin
- Tightening specification. Refer to Figure.
- Left Cylinder Head Gasket
- Left Timing Chain Cover
- Removing and installing. Refer to LEFT AND RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Bracket
- For wiring harness
- Bolt
- Replace
- Tightening specification and sequence. Refer to Figure.
- Lower Timing Chain Cover
- Different versions depending on the vehicle.
- Sleeve installation instructions. Refer to INSTALLING - "Depending on the version, there may be a second sleeve -2- between the sealing flange and cylinder block on the left side of the engine" (See Figure).
- Removing and installing. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Seals
- Replace
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Bracket
- For the connectors
- Bolt
- Replace
- Tightening specification and sequence. Refer to Figure.
- Right Timing Chain Cover
- Removing and installing. Refer to LEFT AND RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Right Cylinder Head Gasket
- Alignment Sleeve
- Quantity: 2
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Engine Speed Sensor -G28-
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. 9 Nm