Engine Coolant Temperature Sensor -G62-, Removing And Installing: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

The engine is cold.

Depending on the model, preliminary work may be required. .

-- Quickly open the coolant reservoir cap and release any remaining pressure in the cooling system and then close it again.

-- Place a cloth underneath to catch any escaping coolant.

TIP:

Different versions depending on models and version.

Attached Version:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Press the locking mechanisms in direction of -arrows- and remove the clip.

-- Remove the Engine Coolant Temperature Sensor -G62- -2-.

Threaded Version:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

-- Remove the bolts -arrows- and the retaining plate -1-.

-- Remove the Engine Coolant Temperature Sensor -G62-.

All:

Replace the O-rings after removing them.

-- Insert the new engine coolant temperature sensor immediately so that as little coolant is lost as possible.

-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING .

There are additional procedures depending on the model. .