General Description - Refrigerant Circuit Components: Condenser

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

The condenser -A- conducts heat from compressed refrigerant gas to the surrounding air.

Courtesy of AUDI OF AMERICA, LLC
This condenses the refrigerant gas to fluid.

NOTE:

Depending on the refrigerant circuit design, the receiver/dryer is installed (integrated) either on the condenser or inside the condenser. Refer to RECEIVER/DRYER, REMOVING AND INSTALLING / CONDENSER, REMOVING AND INSTALLING (vehicle-specific repair information) and the Parts Information.

The condenser is available in different versions and can be differentiated only by the part number on the outside. For version -1-, the condenser is divided into two areas "2 way condenser". For version -2-, the condenser is divided into four areas "4 way condenser".

Courtesy of AUDI OF AMERICA, LLC

This illustration shows a condenser with the receiver/dryer -C- installed.

The gaseous refrigerant enters at the connection -A- into the condenser. The refrigerant is then cooled inside the condenser and becomes fluid.

The liquid refrigerant collects in the receiver/dryer -C- (with dryer) and flows through the lower cooling area towards the connection -B-.

Depending on the design of the condenser (interior volumes, delivery flow, etc.), the refrigerant capacity in a refrigerant circuit may vary. For this reason always pay attention to the correct version and allocation of the condenser. Refer to TECHNICAL DATA - R1234yf / TECHNICAL DATA (vehicle-specific repair information) and the Parts Information.