Electric And Electronic Components And Installation Locations, Rear Final Drive 0BR, 0BS And 0BY (HALDEX-Clutch Generation IV)
WARNING: This page is about a different variant/trim than selected.
- All Wheel Drive (AWD) Control Module -J492-
- Important signals are transmitted from the Engine Control Module (ECM) and ABS control module -J104- via data BUS to the AWD control module --.
- Assembly overview, refer to All Wheel Drive Control Module -J492-, REAR FINAL DRIVE 0BR, 0BS AND 0BY (HALDEX-CLUTCH GENERATION IV) OVERVIEW
- Removing and installing, refer to AWD Control Module -J492-, REAR FINAL DRIVE 0BR, 0BS AND 0BY (HALDEX-CLUTCH GENERATION IV)
- Haldex Clutch Control Valve -N373-
- Haldex Clutch Pump -V181-
- Can be checked in "Guided Fault Finding" using the vehicle diagnostic tester
- Removing and installing, refer to Haldex Clutch Pump -V181-, FINAL DRIVE 02D/0AV
- Data Link Connector (DLC)
- Installed location: Front left footwell
- Accelerator Pedal Position Sensor -G79-