Right Coolant Pipe

Special tools and workshop equipment required

Removing

Fig 1: Releasing EVAP Canister -Arrow B-, Remove Upward -Arrow A-

Courtesy of AUDI OF AMERICA, LLC

-- Release the EVAP canister -arrow B-, remove upward -arrow A- and lay it to the side along with the connected hose -1-.

NOTE:

Ignore -2-.

NOTE:

Use a cloth to catch any leaking coolant.

Fig 2: Identifying Right Coolant Pipe, Coolant Hoses -1 And 3- & Bolt -2-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the coolant hoses -1 and 3- and remove them using the 3094.

-- Remove the bolt -2- and remove the right coolant pipe.

Installing

Install in reverse order, paying attention to the following:

NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Check the coolant level. Refer to FILLING .