Left Flange Shaft
Special tools and workshop equipment required
- Oil Collecting and Extracting Device V.A.G 1782
Removing
General repair instructions, refer to REPAIR INFORMATION .
Observe cleanliness rules when working on transmissions, refer to CLEAN WORKING CONDITIONS .
-- Remove left drive axle. Refer to Removal and Installation .
-- Place the V.A.G 1782 under the transmission.
-- Remove the left flange shaft bolt by installing 2 bolts in the flange and counter holding flange shaft with assembly lever.
-- Remove the flange shaft and the pressure spring.
Installing
Install in reverse order, paying attention to the following:
- Tightening specification, refer to FLANGE SHAFT AND SEALS ON TRANSMISSION OVERVIEW .
-- Press flange shaft against spring force and tighten.
-- Install the drive axle. Refer to Removal and Installation .
-- Transmission fluid level, checking and filling, refer to TRANSMISSION FLUID, CHECKING AND FILLING .