Electronic Damping Control Module

Special tools and workshop equipment required

Removing

Fig 1: Cutting Carpet At Markings As Shown Using A Standard Carpet Knife

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The electronic damping control module -J250- is installed under the right front seat.

-- Remove the right front seat. Refer to Seat Frames .

-- Cut carpet at markings as shown using a standard carpet knife.

-- Fold carpet up and unclip control module -2- -arrows-.

Fig 2: Folding Carpet Up And Unclip Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect electrical connector -1- and remove control module -2-.

Installing

Installation is the reverse of removal, with special attention to the following:

-- If the Electronic Damping Control Module -J250- is replaced, the control position must be reprogrammed.

-- Insert control module access carpet frame Interior Trim

-- Reprogram control position using VAS 5051B