LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> TT Base, 2D Convertible >> Repair and Diagnosis >> Restraints >> Passive Restraints >> Passenger Protection, Airbags, Seat Belts (Roadster) >> 69 Passenger Protection, Airbags, Seat Belts >> General Information >> Restraint System Components, Safety Precautions And Testing Procedures >> Side Airbag Additional Safety Precautions

Side Airbag Additional Safety Precautions

CAUTION:
  • We recommend using original equipment seat covers.
  • Seat covers or extra covers that are not approved specially for use on Audi seats with side airbags must not be used.
  • Do not cut the backrest material in side airbag area.
  • When installing, seam in side airbag region must run straight.
  • All upholstery clips must be replaced (metal and plastic clips).
  • We recommend using original upholstery clips.
  • During installation, all upholstery clips must be placed in the same place as when removed.
  • If cover is damaged (with rips, burned holes, etc.) in side airbag region, it must be replaced for safety reasons so that airbag deploys correctly.
  • Do not repair the backrest cover in the side airbag area (because of special materials and strictly defined seams).
  • Always replace the backrest upholstery if the side airbag deploys.
  • All components, which were damaged in a crash, must be replaced. If the airbag unit appears to be undamaged, it may be used again.
  • If thorax airbag units are replaced, the new thorax airbag number sticker should be removed and placed over the old label on the seat pan.
  • Do not poke the cover with an upholstery needle or other sharp objects in the region of the airbag, front passenger seat occupant sensor -G128- and passenger occupant detection system mat.
scientia non olet · About LEMON Manuals