LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> TT Base, 2D Convertible >> Repair and Diagnosis >> General Information >> OEM General Information >> Wiring (Roadster) >> 97 Wiring >> Removal And Installation >> Relay Panel Under Left Instrument Panel

Relay Panel Under Left Instrument Panel

Observe notes on contact corrosion. Refer to CONTACT CORROSION .

Removing 

Fig 1: Releasing Retaining Spring And Swiveling 5-Position Relay Carrier To Withdraw From Bracket
GWWA97-0799Courtesy of AUDI OF AMERICA, LLC

-- Switch off ignition and remove ignition key.

-- Remove driver side instrument panel cover. Refer to Storage Compartments and Covers in Removal and Installation .

-- Release retaining spring -1-.

-- Tip relay carrier in -direction of arrow- and remove toward right from base mount.

-- Unclip fuse panel on relay carrier.

-- Detach relays and control modules and then unclip appropriate relay carrier.

NOTE:

Check the exact assignment of 5-pin relay carrier in the current wiring diagram. Refer to Wiring Diagram.

Installing 

Install in reverse order of removal. Note the following:

-- Install driver side instrument panel cover. Refer to Storage Compartments and Covers in Removal and Installation .