Relay And Fuse Panel In Engine Compartment E-Box

Observe notes on contact corrosion. Refer to CONTACT CORROSION .

Removing

Fig 1: Identifying E-Box Cover And Latches

Courtesy of AUDI OF AMERICA, LLC

-- With ignition switched off, disconnect battery Ground (ND) wire. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove engine compartment E-box cover by sliding latch in -direction of arrow-.

-- Remove relay -A- and control modules -B- from relay carrier.

Fig 2: Identifying Relay And Control Modules From Relay Carrier, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Remove Suppressor -C24- -item C- from relay and fuse panel and disconnect electrical connector.

-- Release retaining clips -A arrows- and press fuse panel -1 and 2- and relay carrier -4- back out of relay and fuse panel.

Fig 3: Release Clips And Press Fuse Panel And Relay Carrier Back Out Of Relay And Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Release retaining clip -arrow B- and tip relay and fuse panel -3- up -arrow C- out of engine compartment E-box.

Installing

Install in reverse order of removal. Note the following:

-- Connect battery. Refer to Connecting .