Fuse Panel In Right Luggage Compartment

Observe notes on contact corrosion. Refer to CONTACT CORROSION .

Removing

Fig 1: Identifying Fuse Panel In Right Luggage Compartment

Courtesy of AUDI OF AMERICA, LLC

-- With ignition switched off, disconnect battery Ground (ND) wire. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove luggage compartment right side trim. Refer to Removal and Installation .

-- Release retaining clip -arrow- and press fuse panel -1- back out of control module bracket -2-.

-- Remove the fuses from the fuse panel.

Fig 2: Releasing Clips To Remove Cover From Fuse Holder

Courtesy of AUDI OF AMERICA, LLC

-- Release retaining clips -arrows- and remove the cover from the fuse panel.

-- Pull off retaining strip -1- for harness connectors -arrow- and remove harness connectors from connector socket.

Fig 3: Pulling Off Retaining Strip For Harness Connectors To Remove Harness Connectors From Connector Socket

Courtesy of AUDI OF AMERICA, LLC

NOTE:

For exact assignment of fuse panel in right luggage compartment, refer to current wiring diagram. Refer to Wiring Diagram.

Installing

Install in reverse order of removal. Note the following:

-- Install luggage compartment right side trim. Refer to Removal and Installation .

-- Connect battery. Refer to Connecting .