LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> TT Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (2.0L - Turbocharger, Supercharger - Engine Code(S): BPY (Coupe) (As Of 10.2010)) >> Turbocharger, Supercharger >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
Component Bolt Size Nm
Bracket for Wastegate Bypass Regulator Valve - 7
Bracket to Turbocharger6 - 30
Bracket to Turbocharger7 - 23
Charge Air Pressure Sensor - 5
Charge Air Pipe - 10
Connection - 9
Coolant Supply Line2
  - 23
  - 35
Coolant Return Line
  - 9
  - 35
Fastening Strip, Nut5 - 30
Heat Shield - 9
Mount for Charge Air Cooler - 5
Nipple - 8
Oil Return Line - 9
Oil Supply Line1
  - 9
  - 30
Oil Supply Line to Oil Filter Bracket - 25
Right Charge Air Pipe to Oil Pan - 10
Rear Charge Air Tube to Bracket - 10
Turbocharger, Nut3, 5 - 21
Turbocharger Recirculating Valve - 7
Turbocharger Vacuum Diaphragm
-Nut8 - 9
-Bolt - 10
Wastegate Bypass Regulator Valve - 3
  • 1 For bolt tightening clarification, refer to PART II  and see items -2, 5 and 6-
  • 2 For bolt tightening clarification, refer to Part II  and see items -8, 11 and 12-
  • 3 Always replace
  • 4 For bolt tightening clarification, refer to PART III  and see items -3 and 5-
  • 5 Coat stud bolts on exhaust manifold with hot bolt paste.
  • 6 For bolt tightening clarification, refer to PART III  and see items -8-
  • 7 For bolt tightening clarification, refer to PART III  and see items -11-
  • 8 Secure with sealing wax
scientia non olet · About LEMON Manuals