Sill SIDETRIM
The sill side trim can be removed and installed with the front seat installed.
Removing
- Follow all safety precautions when working on pyrotechnic components. Refer to RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES .
-- Bring seat as far up as possible.
-- Remove backrest adjustment wheel. Refer to BACKREST ADJUSTING WHEEL .
-- Remove seat height adjustment handle. Refer to SEAT HEIGHT ADJUSTMENT HANDLE .
-- Remove expanding rivets -2- (quantity: 2).
- Sill-side trim
Expanding rivets on a power front seat are shown in the illustration.
-- Open the clips -5- (quantity: 2) and -4-.
-- Unclip trim -1- on retaining bracket -3-.
-- Disengage trim in area of backrest adjustment wheel and seat anchor.
-- Remove trim forward from retaining bracket -3-.
Ensure bracket -2- is not damaged when removing trim.
Seat with Four-Way Lumbar Support
On vehicles with manual front seats and passenger occupant detection system (country-specific), the driver seal lumbar support adjustment switch -E176- or E177 must be installed so connector is connected from above.
-- Remove connector -1- from Driver Seat Lumbar Support Adjustment Switch -E176- -4-.
2 - Sill-side trim
3 - Retaining bracket
Continuation for all Manual Seats
-- Remove sill side trim.
Installation
Install in reverse order of removal. Note the following:
- Follow all safety precautions when working on pyrotechnic components. Refer to RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES .