Capacities, AUDI 100 And AUDI A6 (4A_), From My 98
Features of the refrigerant system:
- Restrictor (not colored)
- Reservoir
- A/C compressor manufactured by Denso or Zexel / Valeo, Refer to [For engine(s) BPY, CETA, CCTA, CDMA, CEPB] Description and Operation .
| Vehicle model | Production period | Capacity in grams | Differing features of this refrigerant circuit |
|---|---|---|---|
| Audi 100/Audi A6 | From 10.92 to 03.97 | 750 + 50 |
|
If a vehicle is equipped with a yellow colored restrictor as replacement for a non-colored restrictor, add 50 g more refrigerant than specified in the table. In addition, the capacity specified on the label in the vehicle is to be checked and amended if necessary, or the existing label is to be replaced with one indicating the correct capacity (affix over old label).
Restrictors with a modified hole have been installed at the factory since November 1997 (colored). In order to distinguish between the two restrictor versions, the one with the smaller hole (1.54 mm) is yellow colored. The restrictor with the larger hole (1.83 mm) is not colored.
As of calendar year 2006, the Zexel / Valeo identification was changed to Valeo.
From September 1994, production was gradually switched from condenser 4A0 260 403 AB to condenser 4A0 260 403 AC.
The refrigerant capacity of 750+50 g applies to all Audi 100 (regardless of condenser).
Only condensers with part number 4A0 260 403 AC are now available as replacement parts (if necessary, make use of label, part no. 8A0 010 126 P).
After charging refrigerant circuit of vehicles manufactured up to October 1994, check capacity stated on label in vehicle and amend if necessary of affix label, part no. 8A0 010 126 P (modified capacity). Refer to [For engine(s) BPY, CETA, CCTA, CDMA, CEPB] Description and Operation .