LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> TT Base, 2D Convertible >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Exhaust >> General, Technical Data - Refrigerant R134A Servicing (Roadster) (2 Of 2) >> 00 General, Technical Data >> Specifications >> Refrigerant R134A Capacities >> Capacities, AUDI A4 (8D_), From My 95

Capacities, AUDI A4 (8D_), From My 95

NOTE:

Applies also to the Audi RS 4

Features of the refrigerant system:

Vehicle model Production period Capacity in grams Differing features of this refrigerant circuit
Audi A4 From 11.94 to 11.97 650 + 50
  • Restrictor (not colored)
  As of 11.97 700 + 50
  As of 11.98 550 + 50
Audi RS 4 As of May 2000 650 + 50
  • Restrictor colored (yellow)
NOTE:

Restrictors with a modified hole have been installed at the factory since November 1997 (yellow colored). The capacity was increased by 50 g for vehicles with yellow colored restrictor.

In order to distinguish between the two restrictor versions, the one with the smaller hole (1.54 mm) is yellow colored. The restrictor with the larger hole (1.83 mm) is not colored.

The Audi A4 was equipped with different A/C compressors depending on engine and production period. Exclusive use was made at the start of production of Zexel / Valeo A/C compressors. As of MY 1996, Denso A/C compressors were gradually introduced for vehicles with 6-cylinder engines.

Beginning the production year 2006, the name of the Zexel A/C compressor was changed from Zexel to Valeo.

Replacement restrictors with different holes (not colored, yellow colored, red colored) are available. If a vehicle is equipped with a different restrictor, add more or less refrigerant depending on type (→ table). After charging, amend capacity stated on label or affix label indicating new capacity.

Depending on manufacturer, color of red restrictor may tend more towards orange.

As of November 1998, Audi A4 models have also been equipped with AWG condensers (initially approximately 10, 000 vehicles, from vehicle identification number (VIN) 8DXA 065 253 to 8DXA 077 026). The specified capacity for vehicles with these condensers differs from those with Showa condensers. The condensers can be identified on the basis of certain characteristic features. Refer to DISTINGUISHING FEATURES .

If the condenser installed is replaced by one with a different part number, check the capacity indicated on the label in the vehicle and amend if necessary or affix a label with the correct capacity over the existing one. Refer to [For engine(s) BPY, CETA, CCTA, CDMA, CEPB] Description and Operation .