LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> TT Base, 2D Convertible >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Exhaust >> 2.0L - Generic Scan Tool - Engine Code(S): CETA (Roadster) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions >> Monitor-Id $35(53) : Cam Shaft Adjustment

Monitor-Id $35(53) : Cam Shaft Adjustment

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID 35".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min. Max. Additional Information
128 ($80) P0011 VVT diagnosis target position is not reached. 2.5° KW 28° KW Refer to DTC P0011 in the DTC TABLES 
129 ($81) P000A VVT diagnosis target position Slow Response 8° KW 28° KW Refer to DTC P000A in the DTC TABLES 

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals