LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> TT Base, 2D Convertible >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling Fan >> 2.0L - Generic Scan Tool - Engine Code(S): CETA (Roadster) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions >> Monitor-Id $71(113): Secondary Air System (Only SULEV)

Monitor-Id $71(113): Secondary Air System (Only SULEV)

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID 71".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min. Max. Additional Information
130 ($82) P0491 Examination secondary air system, 0 1.999 Refer to DTC P0491 in the DTC TABLES .
133 ($85) P0410 Examination secondary air system, -32.768 32.767 Refer to DTC P0410 in the DTC TABLES 
138 ($8A) P2440 Examination secondary air system, 0 1.999 Refer to DTC P2440 in the DTC TABLES 

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals