Connecting The Vehicle Diagnostic Tester

Special tools and workshop equipment required

NOTE:

Follow the current instructions on the Vehicle Diagnostic Tester. Use the Administration and User Documentation buttons.

Procedure

-- Engage the parking brake or operate the electromechanical parking brake.

-- Shift the shifter lever into neutral or place the selector lever in the "P" or "N" position.

-- Turn off the ignition and connect the Vehicle Diagnostic Tester to the diagnostic connection with the diagnostic cable -arrow-.

Fig 1: Locating Data Link Connector

Courtesy of AUDI OF AMERICA, LLC

-- When using the Remote diagnosis head VAS 5054 A or the Diagnosis interface VAS 5055 refer to the Operating Instructions.

-- Switch on ignition.

-- Turn off all electrical consumers.

NOTE:

If a error message appears on the screen of the Vehicle Diagnostic Tester, refer to the Operating Instructions.