Cleaning Contact Surfaces With The Contact Surface Cleaning Set Vas 6410: Protecting
Special tools and workshop equipment required
- Contact Surfaces Cleaning Set VAS 6410
NOTE:
- Using the Contact surface cleaning set VAS 6410 VAS 6410, service work can be performed in the area of the contact sensor on the threaded connection wiring harnesses in the high current circuit (starter and charging current).
- The gray sanding pads are for slight contamination and suitable for "soft surfaces". The red sanding pads are for heavy contamination and suitable for "hard surfaces".
CAUTION:
Danger of corrosion.
- Missing protection leads to the electrical system damage.
NOTE:
- All threaded connections must be tightened to the specified torque.
- Always use the accompanying hose on the protection container.
- Protection wax is used in the cool area and cavity protection wax is used in the warm area.
- The protection material draws itself into the affected places by capillary action.
-- Hold the injector under the wiring eyelet and spray all around the pins.
-- Hold the injector above the wiring eyelet and spray all around the pins and wiring eyelet.