Left Instrument Panel Fuse Holder
Observe notes on contact corrosion. Refer to CONTACT CORROSION .
Removing
-- With ignition switched off, disconnect battery Ground (ND) wire. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove driver side instrument panel cover. Refer to Storage Compartments and Covers in Removal and Installation .
-- Remove bolts -arrows- for fuse panel -1-.
-- Remove fuse panel from central tube for instrument panel.
-- Release cover for fuse panel -arrows-.
-- Remove the fuses from the fuse panel.
-- Unclip socket and remove connectors from fuse panel.
Check the exact assignment for fuse panel in the current wiring diagram. Refer to Wiring Diagram.
Installing
- Tightening specification, refer to RELAY CARRIER AND FUSE PANEL OVERVIEW .
Install in reverse order of removal. Note the following:
-- Make sure the fuse panel -2- sits at the top of the central tube behind the mount -1-.
-- Install driver side instrument panel cover. Refer to Storage Compartments and Covers in Removal and Installation .
-- Connect battery. Refer to Connecting .