Diagonal Braces, Roadster

Special tools and workshop equipment required 

• Torque Wrench V.A.G 1331

Removing 

Fig 1: Supporting Driveshaft With A Wooden Block At Tunnel Support

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolts -1- and -3- and remove diagonal braces -2-.

Installing 

Installation is performed in the reverse order of removal. Observe the following when doing so:

Tightening specifications, refer to SUBFRAME, DIAGONAL BRACES, CROSSMEMBER, LOWER TRANSVERSE LINK, UPPER TRANSVERSE LINK, TIE ROD AND LEVEL CONTROL SYSTEM SENSOR ASSEMBLY OVERVIEW, ROADSTER .