Hex Bolt Between Drive Axle And Wheel Hub (Loosening And Tightening)
Special tools and workshop equipment required
- Angle Wrench V.A.G 1756
Loosening
-- Only loosen drive axle to wheel hub threaded connection a maximum of 90° when vehicle is resting on its wheels, otherwise wheel bearing will be damaged.
-- Raise vehicle enough that wheels hang freely.
-- Operate brake (second mechanic required).
-- Remove bolt -arrow-.
Tightening
-- Replace bolt -arrow-.
NOTE:
- Before installing, threads in constant velocity joint should be cleaned with a tap.
- Wheels must not yet touch the ground to tighten the drive axle, wheel bearing may otherwise be damaged.
-- Operate brake (second mechanic required).
-- Tighten bolt to 200 Nm.
-- Lower the vehicle onto its wheels.
-- Tighten bolt an additional 180°.