Right Flange Shaft Needle Bearing

Special tools and workshop equipment required 

• Thrust Plate VW 401
• Thrust Plate VW 402
• Punch VW 407
• Thrust Disc VW 412
• Subframe Support Assembling Device VAS 3253
• Assembly Tool T10047

Procedure 

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT .

-- Mount the T10047 as illustrated.

• The markings "B" on both parts face each other
• The depressions -arrows- must be under the bearing.

-- Bolt the parts together.

-- Remove the locking ring -A-.

-- The shaft must be rotated while pressing off -arrow- so that the contact surface on the needle bearing does not get damaged.

-- The shaft must be rotated while installing -arrow- so that the contact surface on the needle bearing does not get damaged.

-- Secure the needle bearing with a new circlip.

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT .