LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> TT Base, 2D Convertible >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Axle Shafts >> Rear Suspension (Roadster) >> Rear Suspension >> Removal And Installation >> Front Wheel Drive (Fwd) >> Trailing Arm With Mounting Bracket >> Removing

Trailing Arm With Mounting Bracket: Removing

-- Remove the wheel.

-- Remove stone guard from trailing arm. Refer to STONE GUARD .

-- Remove coil spring. Refer to COIL SPRING .

-- Remove the bolt -arrow- for parking brake cable -1- from trailing arm -2-.

Fig 1: Identifying Parking Brake Cable, Bolt And Trailing Link
GWWA42-0430Courtesy of AUDI OF AMERICA, LLC

-- Remove the coupling rod -1- from trailing arm.

Fig 2: Identifying Wheel Bearing Housing Bolts And Connecting Link At Trailing Arm
GWWA42-0429Courtesy of AUDI OF AMERICA, LLC

-- Remove bolts -arrows-.

-- Mark installation position of mounting bracket on body.

-- Remove bolts -arrows-.

Fig 3: Identifying Trailing Link, Mounting Bracket And Bolts
GWWA42-0431Courtesy of AUDI OF AMERICA, LLC

-- Remove trailing arm with mounting bracket.

NOTE:
  • If longitudinal control arm is being replaced, mounting bracket must be removed from trailing arm.
  • Installation position of mounting bracket to longitudinal control arm must then be adjusted.