Apply Sealant -Hatched Area- To Clean Cover Surface
- Sealant bead: Unbroken, 2 to 3 mm diameter Guide past inner hole area -arrow-.
-- Align new cover with bolts -arrows- to bolt holes.
It must be aligned exactly because it cannot be aligned after driving on.
-- Drive cover on with a plastic hammer.
-- Wipe off any sealant -- leaking out.
The CV boot is frequently pressed in when placed on the CV joint body. This creates a vacuum in the CV boot, which pulls a fold inward when the car is driven -arrow-.
Therefore, observe the following:
-- Before clamping the clamping sleeves, balance pressure by raising protective joint boot.