Stainless Steel Clamps For HYTREL Protective Joint Boots, TENSIONING

Fig 1: Locating Small And Large Clamps On Outer Joint

Courtesy of AUDI OF AMERICA, LLC

-- Position V.A.G 1682 as shown in illustration. Be sure that edges of clamping pliers are seated in corners -arrows B- of hose clamp.

-- Tighten hose clamp by turning spindle -A- using a torque wrench (do not tilt clamping pliers).

NOTE:

Be sure thread of spindle in clamping pliers moves freely. Grease with MOS ₂ grease, if necessary.

If it does not move freely, e.g. due to dirt in thread, the required clamp tension will not be achieved at the specified torque.