Front Brakes, TT RS, Servicing

Install complete repair set
After replacing brake pads, depress brake pedal several times firmly to properly seat brake pads in their normal operating position.

Fig 1: Front Brakes, Components Overview

Courtesy of AUDI OF AMERICA, LLC

Bleed Screw
- 10 Nm
  NOTE:
  Bleed the brake caliper at each bleed screw.
Bolt
- 200 Nm
- Remove when removing the brake caliper
  NOTE:
  Replace the bolts each time it is removed
Speed Sensor
Bolt
- 8 Nm
- For the speed sensor.
Brake Caliper
NOTE:
Do not hang on the brake hose after removing. Secure to the body with wire.
- Removing and Installing FRONT BRAKE CALIPER, TT RS
- Replace FRONT BRAKE CALIPER, TT RS
Brake Rotor
- Wear limit FRONT BRAKE PADS, TT RS
  NOTE:
  Remove brake caliper prior to removing
- Removing and Installing FRONT BRAKE ROTOR TT RS
Bolt
- 4 Nm.
- For securing the brake rotor.
  NOTE:
  Use a new bolt after removing.
Brake Pads
- With a brake pad wear wire only in the left brake caliper.
- Wear limit FRONT BRAKE PADS, TT RS
- Removing and Installing FRONT BRAKE PADS, TT RS
  Before installing the brake pads, clean the pad guides and coat them grease.
  
  Peel off the adhesive film before installing the pads
Brake Pad Wear Wire
- Installed only in the left brake caliper.
Clip
- Make sure that it is installed in the correct position
  NOTE:
  Install the brake pad wear wire into the clip. Installed only in the left brake caliper.
Brake Pad Pin
NOTE:
Be careful not to scratch or damage the brake caliper when removing and installing it.
Bolt
- 18 Nm.
- For the bracket
Brake Hose
- 35 Nm.
- Install in the brake caliper.
- Install the in the bracket.
  Tightening specification 35 Nm, brake hose to the brake caliper for "TT RS"
  
  NOTE:
  seat properly in retainer Do not twist it when installing
Bracket
- For the brake hose and the brake pad wear wire.