Screw for Convertible Top Height Adjustment
-- Prior to convertible top removal, the screw for convertible top height adjustment -1- on lower main bearing -2- must be unscrewed to the convertible top compartment floor.
Height Adjustment at Main Bearing
-- During installation, the main bearing must be installed for preadjustment at a distance of -a- = 77 mm from the convertible top compartment front wall with respect to the upper edge of the main bearing front side.
Gap Dimensions on Convertible Top
The gap dimensions are set by adjusting at the main bearing.
Measure the dimension -c- from the forward edge of the rear lid outward
Dimension -d- must be measured from the side panel starting at the main bearing.
Dimension -f- can be adjusted by placing adjustment shims on the upper seal guide rails CONVERTIBLE TOP SEALS .
- Dimension -a- = 7 mm
- Dimension -b- = 1.5 mm
- Dimension -b- can be adjusted by adding or removing shims between the front rail and convertible top lock.
- Dimension -c- = 14 mm
- Dimension -d- = 4.5 mm
- Dimension -e- = 1.5 mm
- Dimension -f- = 12 mm
- Adjust the dimension -f- by adding or removing washers from between the guide rail and roof guide, refer to CONVERTIBLE TOP SEALS
- Body window crossmember
- Convertible top
- Body
- Side panel
- Door window