Bringing Front Seats Into Service Position
Special tools and workshop equipment required
- Trim removal wedge 3409
Service Position, Implementing
-- Bring headrest into lowest lock position.
-- Move seat as far back and up as possible.
Only with Electrically Adjustable Seat
The surrounding area was not shown in the illustration for clarity purposes.
-- Pry cover caps -1- from seat rail covers -3- and seat fore/aft adjustment spindle -2- with Trim Removal Wedge 3409.
Procedure for All Vehicles
-- Unclip rear cover -1- with the trim removal wedge 3409 and pull the cover in the direction of -arrow- off of connector station -2-.
Do not disconnect electrical wires.
Service Position, Resetting
Install in reverse order of removal. Note the following:
-- Make sure the cover tab slides into connector station correctly.
-- Engage the cover correctly with the connector station.