Control Position, Programming Using Vehicle Diagnostic Tester

WARNING:

During a test drive, the testing and measuring equipment must always be secured on the back seat.
These devices may be operated only by a passenger during a test drive.

-- Connect Vehicle Diagnosis Tester with corresponding diagnostic cable to vehicle.

-- Switch on the Vehicle Diagnosis Tester.

The Vehicle Diagnosis Tester Is Ready For Operation When The Operating Modes Are Displayed.

-- Switch on ignition.

Requirements

The vehicle must be standing on an even surface.
The vehicle may not be loaded.
The electronic damping control module -J250- must be coded.
The DTC memory may not contain any vehicle level sensor DTC memory entries.

NOTE:

If control modules or electric/electronic components were replaced, then the components must be adapted under "Guided Functions".

-- Touch Guided Functions and the screen.

Then:

-- Select the corresponding program in "Guided Functions ".

-- Follow the prompts on the screen.

NOTE:

If the control position was programmed again on vehicles with lane assist, the directional stabilization assistance control module -J759- with integrated camera must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .