Hydraulic Pressure Sensor 1 -G545- And Hydraulic Pressure Sensor 2 -G546-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .

-- Release the catches -arrows- from the connector for the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 -G546- -2- and disconnect from the Transmission Control Module -J217-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector using the :T40305 .

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the bolts in the sequence -7 to 1-.

Fig 1: Hydraulic Pressure Sensor 1 and Hydraulic Pressure Sensor 2 - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 -G546- with the retaining plate -arrow A- and wiring guide -arrow B-.