LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S5 4.2, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 603 (3.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CCBA, CGXC & CTUB (Sedan)) >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Left Cylinder Head Cover, Removing And Installing >> Installing

Left Cylinder Head Cover, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the cylinder head seal if it is damaged.

Replace the cylinder head cover bolts when replacing the damaged seal.

Replace the O-ring.

-- Clean any oil or grease off the sealing surfaces.

-- Tighten the left cylinder head cover bolts. Refer to Figure.

-- Install the ignition coils. Refer to IGNITION COILS, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals