Seat height adjustment handle, removing and installing: Notes

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Height Adjustment Handle Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Seat height adjustment handle

Create an assisting tool Preparing assist tool to remove seat height adjusting handle .
Pull seat height adjustment handle - 1 - away from seat a little.
Guide assisting tool - 2 - into mount - 4 -.
Pull assisting tool - 2 - in - direction of arrow A - to push spring - 3 - back.

Pull seat height adjustment handle - 1 - in - direction of arrow B -.

Installing

Installation is reverse of removal. When doing so, note the following:

Ensure retaining clamp is positioned on seat height adjustment handle lever. Note installation position Retaining clamp installation position .

2 - Assisting tool

3 - Spring

4 - Mount