Disconnecting connections
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Observe safety precautions for work on airbags → Airbag safety precautions .
- Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can be done by touching door striker, for example.
1 - Front seat
2 - Belt buckle sensor connector (black)
3 - Seat heating connector (green)
4 - Current supply connector (red)
5 - Airbag connector (yellow)
6 - Panel or cover
- For connector station
- Removal
- Tip front seat - 1 - back.
Vehicles without modular wiring routing through 08.05
- Remove coupling station cover - 6 - upward.
Vehicles with modular wiring routing from 08.05
- Remove connector station cover → Modular wiring routing with corrugated tubing on front seat .
Procedure for all vehicles
- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.
- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.
- Press in tab on airbag connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.
- For vehicles with seatbelt fasten sensor: Press in tab on connector for seatbelt fasten sensor - 2 - on tunnel side and disconnect connector for seatbelt fasten sensor - 2 -.
- Connect airbag adapter → Airbag Adapter VAS 6036, connecting .
- Installing
Installation is reverse of removal.