Sill and tunnel side trim panels, assembly overview
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Front seat
2 - Tunnel side trim
- Removing and installing → Tunnel side trim panel, removing and installing
3 - Expanding rivet
- Qty. 4
4 - Rear sill side trim
- Removing and installing Front and rear sill side trim, removing and installing
5 - Bracket
6 - Screw
- 1.0 Nm
7 - Screw
- 3.5 Nm
8 - Assembly cover
- Removing and installing Assembly cover, removing and installing
9 - Bracket
- Qty. 2
10 - Eyelet
11 - Drivers Seat Lumbar Support Adjustment Switch E176 or Front Passenger s Seat Lumbar Support Adjustment Switch E177
- Removing and installing → Four-way lumbar support switch, removing and installing
12 - Actuator
- For Backrest Adjustment Button E425
- Pry out with Trim Removal Wedge 3409
13 - Actuator
- For Seat Fore/Aft Adjustment Button E418
- For Inclination Adjustment Button E421
- For Seat Height Adjustment Button E424
- Pry out with Trim Removal Wedge 3409
14 - Catch
15 - Front sill side trim
- Removing and installing Front and rear sill side trim, removing and installing
16 - Connector
- Qty. 3
17 - Front retaining bracket
- Removing and installing → Front retaining bracket, removing and installing
18 - Upper retaining bracket
- Removing and installing → Upper retaining bracket, removing and installing
19 - Rear retaining bracket
- Removing and installing → Rear retaining bracket, removing and installing